What are the precautions for Exhaust Fan for Soldering Station? Now let's list them one by one:

(1) When booting, first connect to the compressed air to the gas storage tank, connect the control power supply, and start the ash device. If there are other equipment in the system, the downstream device should be started first.

(2) During the shutdown, there is no need to cut off the compressed gas source. Especially when working in a fan, it is necessary to provide compressed air to the improvement of the valve cylinder to ensure the opening of the valve.

(3) The oil and water separator in the three connections of the gas storage tank and gas source should be seized once per shift. At the same time, the oil -water separator should be washed every 3 to June. The oil fog device should be checked frequently and refueling in time.

(4) If the electromagnetic pulse valve is faulty, it should be excluded in time. If there is impurities and moisture inside, it should be cleaned. If the diaphragm damage should be replaced in time.

(5) When the dust collector works normally, the gray device cannot stop working. Otherwise, the ash will soon fill the dust to overflow into the bag, forcing the dust collector to stop working.

(6) Regularly determine process parameters, such as flue gas, temperature, concentration, etc., find abnormalities, find the cause and deal with it in time.

(7) Management personnel should be familiar with the principles, performance, and use conditions of the dust collector, and master the adjustment and maintenance methods.

(8) When stopping, after the process system is stopped, the dust collector and exhaust device should be kept working for a period of time. Clear the ash (manually clear the ash) to remove the dust on the dust filter bag to prevent the bag from being affected by the moisture.

(9) Mechanical movement components such as reducer and ash -mouting devices shall be injected and replaced in accordance with regulations. It is found that abnormal phenomena should be excluded in time.

(10) Using a timing -style ash clearance controller shall regularly determine whether the ash clearing cycle is accurate, otherwise it should be adjusted. Use a fixed -resistant pulse controller to check the working conditions of the pressure switch regularly, whether the pressure port is blocked, and clean up.

exhaust fan for soldering station https://www.kaisenfilter.com/KSZ-3-0D-Welding-Fume-Extractor.html